If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Good morning, I have the following problem. I used the DC-Phoenix software to unlock the FRP. And at the end of the process I get the following message:
"Writing rescue_recovery partition with file recovery rescue_recovery partition UPDATE ... OK Looking for device in upgrade mode ..."
The phone restarts and stays in update mode with a circle and does not exceed 5%.
Can you help me?
It's a Huawei P8 Lite 2017
Thank you very much
Hello, DC-phoenix does not unlock FRP. FRP erase guide here https://www.dc-unlocker.com/huawei-a...one-frp-unlock
Flashing may not go through in upgrade mode if country/vendor does not match with phone and file that you flash. So you would need to repair these first if phone can boot up. If it can't then need to use method 2 in order to revive it. DC-phoenix guide for repair here https://www.dc-unlocker.com/DC-Phoen...epair-tutorial
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment