The only way to unbrick it's to flash this board software:
PRAMAA001047_Board Software_general_Android 7.0_EMUI 5.0_05022FNT.dgtks
Done, it works well.
Now I can flash any firmware. Thank you.
Unconfigured Ad Widget
Collapse
Announcement
Collapse
No announcement yet.
P8 Lite 2017 PRA-LX1C02B139 bricked
Collapse
X
-
You should attempt to use any board software available to your phone.
Leave a comment:
-
I tried method 3, but I can't find full repair firmware. Where I can download it?
Leave a comment:
-
Thank you. Is this firmware correct "Huawei P8 Lite 2017 PRA-LX1 PRA-L11 hw eu HLRCF Prague-L31 8.0.0.402(C432) Firmware 8.0.0 r1 EMUI8.0 05014FFV"?
Original was PRA-LX1C02B139
Anyway, I have done a firmware request in the right topic of this forum, so I'll try different ones
Leave a comment:
-
P8 Lite 2017 PRA-LX1C02B139 bricked
Hi, I have a P8 Lite 2017 bricked. The device enter into fastboot mode, but not in update mode and recovery. I've tried to unbrick with DC Phoenix method 2, but I get this message:
Looking for a device in fastboot mode
Device found: 57UDU17111025954
Getting IMEI...
Getting build number...
Getting model ...
Getting battery state...
Getting backdoor info...
Getting lock state info...
Getting lock boot info...
SN:57UDU17111025954
IMEI:86xxxxxxxxxxxxx8
IMEI1:000000000000000
Build number: :PRA-LX1C432B161
Model: PRA-LX1
Vendor/Country: Vendor/Country: hw/eu
Battery state: 3916mv
OEM lock state info:
FB LockState: UNLOCKED
USER LockState: LOCKED
OEM get bootinfo:
unlocked
Process identifier:22104799
Getting build number...
Getting base version...
Getting cust version...
Getting preload version...
Erasing ver .. .
File size: 4.027.721.900 bytes
Current version(CURVER): Prague_C900_EMUI8.0
Writing rescue_recovery_kernel partition
RESCUE_RECOVERY_KERNEL partition update ...OK
Writing rescue_recovery_ramdisk partition
RESCUE_RECOVERY_RAMDISK partition update ...OK
Writing rescue_recovery_vendor partition
RESCUE_RECOVERY_VENDOR partition update ...OK
Cannot enter in Recovey modeLast edited by vinzzz; 2020-01-13, 12:28 PM.Tags: None
Leave a comment: