sht-w09 firmware failed!!!!!! after black screen!!!!!!!!

[gdsmsla]

DC Phoenix 0.0.0.164
user:gdsmsla

Looking for a device in upgrade mode
No devices detected in upgrade mode
Device found: JJN6R18C05000030


Advanced update
Not Reboot checked
Update Verlist to server on file load NOT checked
Enable testpoint NOT checked
Disable testpoint NOT checked
Try Rescue Recovery checked
Bypass version check checked
Old slow algo checked

Detecting recovery partition
File size: 3,827,577,028 bytes
Current version(CURVER): SHT-W09_Global-CUST 9.0.1(C999)
ERECOVERY_KERNEL partition found
ERECOVERY_RAMDISK partition found
ERECOVERY_VENDOR partition found

2022-01-06 오전 2:02:31 Starting to try Rescue Recovery...


Looking for a device in fastboot mode
Device found: JJN6R18C05000030


Getting IMEI...
Getting build number...
Getting model ...
Getting battery state...
Getting backdoor info...
Getting lock state info...
Getting lock boot info...

Build number: :SHT-LGRP3-OVS 9.1.0.330
Model: SHT-W09
Vendor/Country: hw/kr
Battery state: 0
OEM lock state info:
FB LockState: LOCKED
USER LockState: LOCKED
OEM get bootinfo:
locked

Getting base version...
Getting cust version...
Getting preload version...
Preload Version is EMPTY

Process identifier:38778332


Erasing ver .. .
File size: 3,827,577,028 bytes
Current version(CURVER): SHT-W09_Global-CUST 9.0.1(C999)
Writing rescue_recovery_kernel partition
RESCUE_RECOVERY_KERNEL partition update ...OK
Writing rescue_recovery_ramdisk partition
RESCUE_RECOVERY_RAMDISK partition update ...OK
Writing rescue_recovery_vendor partition
RESCUE_RECOVERY_VENDOR partition update ...OK
Update recovery parttion OK

USB Device REMOVAL
Type: @oem156.inf,%hwfastboot%;Android Sooner Single ADB Interface
VidPid: VID_18D1&PID_D00D
Instance id: JJN6R18C05000030
Looking for device in upgrade mode...
Process was cancelled by user
Enter recovery mode FAIL

Cannot enter in Recovery mode



When the firmware was initially installed, the recovery mode was entered during the reboot process after the recovery installation, but the screen is no longer turned on after the update failed phrase appears on the sht-w09 screen. This program intensified the problem.
If it's hard to recover from the administrator's view, please get a refund.

[Valdemaras]

Refund for flashing not available as per warning message on software when it launches unless the account wasn't used at all. What you can do is to flash your device with board software alone and attempt to boot up and start the repair from it.