How To Enable Network Band Selection while a Connection is ON

[sandeep88822]

see this screenshots....

cant change after connected m8,,

if u first go to options nd select network

then leave it as it is


nd connct it from dial up.


after conected switch as many times as u want

[-OvERLoRD-]

see this screenshots....

[-OvERLoRD-]

sandeep how you do that??? if i open network selection dialog in mobile partner and try to connect from windows dial up network i got error that modem or other device used by another application...

please help me yar...

[sandeep88822]

just see the attached file

[sandeep88822]

How To Enable Network Band Selection while a Connection is ON
...
How to set Huawei Mobile Partner Network Band Selection as
"WCDMA Only" from "WCDMA PREFERRED"
when a connection is going on?
...
I'm using Huawei E160. At my home, I have a poorer 3G coverage, and thats why "WCDMA PREFERRED" mode works better, signal may totally go of if its "WCDMA Only".
But, if I start a connection on "WCDMA PREFERRED" mode at my home, and then move by car to my office, where 3G coverage is fair, and a "WCDMA Only" mode is more suitable.

The bug in the current versions of Huawei Mobile Partner is that, it does't allow switching between bands, once you start a connection. The buttons donot work.

So, whenever I tend to change the Reception Band, i have to close the connection. And manytimes sacrifice some non-resumeable downloads.


Is there a way I can switch from
"WCDMA Only" from "WCDMA PREFERRED" without closing the connection?


Thanks

i had also faced this problem, so i hv a tricky solution which actually works.

i hope u can create a dialup using ur modem.
solution is currently tested on win 7
opn mobile partner, options,network

it will open if u hv not connected yet. ok.

now connect through dial up not from mobile partner

thus u can change it to cdma only, gsm only as many times as u want.

remember open mobile partener/options/network without connecting..

[BJFROG]

the network dont allow you to do something like that once a connection has been established

[DJwa163]

How To Enable Network Band Selection while a Connection is ON
...
How to set Huawei Mobile Partner Network Band Selection as
"WCDMA Only" from "WCDMA PREFERRED"
when a connection is going on?
...
I'm using Huawei E160. At my home, I have a poorer 3G coverage, and thats why "WCDMA PREFERRED" mode works better, signal may totally go of if its "WCDMA Only".
But, if I start a connection on "WCDMA PREFERRED" mode at my home, and then move by car to my office, where 3G coverage is fair, and a "WCDMA Only" mode is more suitable.

The bug in the current versions of Huawei Mobile Partner is that, it does't allow switching between bands, once you start a connection. The buttons donot work.

So, whenever I tend to change the Reception Band, i have to close the connection. And manytimes sacrifice some non-resumeable downloads.


Is there a way I can switch from
"WCDMA Only" from "WCDMA PREFERRED" without closing the connection?


This facility was quite well available on many 3G mobile phones. This is possible on
Nokia Symbian OS9.2 and later Phones). So, I'm not just speculating, its technically not impossible.
...

I hope, some of you will come up with a solution.
It could be greatly helpful. Please reply.

Thanks