Tweet
Hello.
I got the k3805-z modem about 3 days ago and it worked fine on my win7 32bit laptop until now. Whenever I plug the device into the usb port, it loads fine, autoruns and is detected in VMB. The problem is that after detection, the connection notification says 'enabling device' and stops there.
I have tried the following:
Used all VMB and VNC programs from 9.4.8 to 10.1.108.29105RP156
Manually uninstalled and reinstalled all device related to the modem in Control Panel
Deleted all drivers related to the modem off of the harddrive before doing a fresh install
Using different usb ports - did not work
Installed the device on a different laptop (x86) also did not work.
before it happen i choose disable power when application close at vmb and then it happen. any suggestion to enabling my modem???
The symptoms are:
The device will flash red until it is picked up by the operating system and then stop blinking (no light flashing). VMB will then show 'enabling device' and stop there.
thanks.
I got the k3805-z modem about 3 days ago and it worked fine on my win7 32bit laptop until now. Whenever I plug the device into the usb port, it loads fine, autoruns and is detected in VMB. The problem is that after detection, the connection notification says 'enabling device' and stops there.
I have tried the following:
Used all VMB and VNC programs from 9.4.8 to 10.1.108.29105RP156
Manually uninstalled and reinstalled all device related to the modem in Control Panel
Deleted all drivers related to the modem off of the harddrive before doing a fresh install
Using different usb ports - did not work
Installed the device on a different laptop (x86) also did not work.
before it happen i choose disable power when application close at vmb and then it happen. any suggestion to enabling my modem???
The symptoms are:
The device will flash red until it is picked up by the operating system and then stop blinking (no light flashing). VMB will then show 'enabling device' and stop there.
thanks.