Vincentas, Gintas et al;
Originally when I connected via usb, the virtual drive + a link to the SD automatically appeared in My Computer, the drivers loaded - good to go.
After attempting to unlock this thing with DC- Unlock - unsuccessfully - the unit doesn't function the same. No virtual drive, no driver install, no SD mem card access. It does show up in the HW manager as a "ZTE Proprietary USB Modem" but of course DC-Unlocker doesn't see/ detect it as before.
Initially the unit registered as a "ZTE Mobile Connect - Network Adapter" just as the Huawei UMG 587 I'm using now.
Now a quick "primer" here:
This was my first time using your service - recommended buy an associate who successfully unlocked the Huawei I'm using now. I wasn't clear on the "Buy Credits" detail at first and subsequently did so. The second attempt seemed to run as expected - detection O.K. etc.
I didn't mess with the COMs selected nor the flash function.
Any I ideas on how to revert back to the original configuration or what the H**L happened?
Best, Regards.
P.S.: I find your web sight lacking any clear new user friendly descriptive "walk-through".
Maybe it's just me?
Originally when I connected via usb, the virtual drive + a link to the SD automatically appeared in My Computer, the drivers loaded - good to go.
After attempting to unlock this thing with DC- Unlock - unsuccessfully - the unit doesn't function the same. No virtual drive, no driver install, no SD mem card access. It does show up in the HW manager as a "ZTE Proprietary USB Modem" but of course DC-Unlocker doesn't see/ detect it as before.
Initially the unit registered as a "ZTE Mobile Connect - Network Adapter" just as the Huawei UMG 587 I'm using now.
Now a quick "primer" here:
This was my first time using your service - recommended buy an associate who successfully unlocked the Huawei I'm using now. I wasn't clear on the "Buy Credits" detail at first and subsequently did so. The second attempt seemed to run as expected - detection O.K. etc.
I didn't mess with the COMs selected nor the flash function.
Any I ideas on how to revert back to the original configuration or what the H**L happened?
Best, Regards.
P.S.: I find your web sight lacking any clear new user friendly descriptive "walk-through".
Maybe it's just me?
Comment